Certified passive dual-band antenna
Iridium Passive Omnidirectional Antenna (+GNSS)
- Passive Antenna for Iridium terminals
- Requires no pointing towards satellite
- Smooth surface low loss radome
- Compact dual-band (SAT/GPS) antenna design
- Built-in active GNSS antenna
- Mounts on any US-style Mounting Bracket with 1"-14NF threaded stud (not supplied)
Note: Cable loss below 3 dB for SAT is recommended
All cables listed here comply with regulations
- Frequency
- 1616 - 1626.5 MHz (SAT) 1561.1 MHz, 1575.42 MHz, 1598.1 - 1605.4 MHz (BeiDou, GPS/Galileo & GLONASS)
- Impedance
- 50 ohm
- Vswr
- < 1.5
- Satellite System
- Iridium BeiDou, GPS, Galileo & GLONASS
- Polarisation
- RHCP
- Axial ratio
- < 6 dB
- Gain
- 2 dBic
- LNA GAIN
- 25 dB (GNSS)
- NOISE FIGURE
- 1.2 dB (GNSS)
- SUPPLY VOLTAGE
- 3.0 - 5.5 V DC (GNSS)
- AVERAGE CURRENT CONSUMPTION
- 20 mA
- Color
- White (non-glossy)
- Height
- 150 mm (191.5 mm mounting base included)
- Diameter
- Ø 95 mm
- Mounting
- On any US-style Mounting Bracket with 1"-14NF threaded stud (not supplied)
- Mounting Place
- On marine vessel or landbased vehicle
- Materials
- ASA, copper, PCB, stainless steel and brass
- Operating Temperature
- -40°C to +70°C
- Connector
- SAT: N-female GNSS: SMA-female
- Cable
- No cables supplied
- Ingress Protection
- IP68
- Serial No.
- On product label
- 65002-001
- Antenna only - in polybag
- Type
- Polybag or hardbox (See "Part No.")
Disclaimer
Scan Antenna reserves the right to change product specifications and information without prior notice. All rights reserved.
